Owner's Board

trim not holding up

This topic has 4 replies, 3 voices, and was last updated 13 years, 10 months ago by clownshoes.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
August 5, 2012 at 8:40 pm #260279

Danny B
Participant

Yesterday I trimmed up while fishing and motor went down, did that 3-4 times, today worked good all day. Dont think its hydraulic flued it goes up good is there a relay or something electric to look for. thanks

August 5, 2012 at 11:16 pm #260280

clownshoes
Participant

Gotta be a leak in rams or enough air at this point to not support motor. I would check resevior levels for your motor and see what you got!C.O.D. Jr. III

August 6, 2012 at 5:55 pm #260281

Grant2
Participant

Look on the drivers side threw a hole where the rams are there is a flat head screw tighten it a little dont force it just give it a snug and then check your fluid.

August 6, 2012 at 10:56 pm #260282

Danny B
Participant

Ok I checked that flat head screw and could not move left or wright. fluid is good. What now. Thanks

August 7, 2012 at 2:07 am #260283

clownshoes
Participant

Dealer. Gotta be loss of pressure/support in Rams. I would check it on big ram and then smaller ones to narrow the field. Wonder if motor failure can do this?Last edited by clownshoes on August 7th, 2012, 2:36 am, edited 1 time in total.C.O.D. Jr. III
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats