Owner's Board

Tightening motor bolts…

This topic has 3 replies, 2 voices, and was last updated 14 years, 11 months ago by Bass Cat Boats.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
June 25, 2011 at 9:21 am #328438

VTBassCat
Participant

11 Cougar. I have a 3 bank and a 1 bank charger mounted on top of the heads of the middle motor bolts. Any trick to accessing these so I can tighten them up?Bill Spence St. Albans, VT [url=mailto:billspence@yahoo.com]billspence@yahoo.com[/url] http://www.twinstatebassin.com Bass Cat Boats http://www.basscat.com Vexilar Marine Electronics http://www.vexilar.com

June 25, 2011 at 2:39 pm #328455

Bass Cat Boats
Keymaster

They should not require tightening in the near term. BCB

June 25, 2011 at 3:42 pm #328473

Bass Cat Boats
Keymaster

They are loose enough to turn easily. Not snug at all. I can turn the nuts (and bolts) easily. The middle two of the six are what I am concerned with. I can get at the others.Bill Spence St. Albans, VT [url=mailto:billspence@yahoo.com]billspence@yahoo.com[/url] http://www.twinstatebassin.com Bass Cat Boats http://www.basscat.com Vexilar Marine Electronics http://www.vexilar.com

June 25, 2011 at 4:02 pm #328494

Bass Cat Boats
Keymaster

You will have to drop the charger to access those. Not sure how many hours are on this rig though that is unusual. Your dealer might be able to assist on this. Nice job checking the tension on those bolts also.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats