While out on the water today after running to my first spot and fishing for a while when I went to run to another spot the motor didnt want to start. It was cranking like the battery was low. The depth finder cut off when trying to start the motor and then turn back on(this went on for most of the day). The picture is what I saw on my Nexsyslink gauge. The manual that comes with this thing is not very good it doesnt give a lot of information. If you notice at the top of the gauge there is a little icon that looks like it has two plugs on the ends with and “x” in the middle. It is not described in the manual anywhere. Also all the readouts have question marks next to them. The motor finally kicked over but the error stayed for several more hours until I went to move spots at that time an audible alarm went off and a “W F” started flashing on the guage. I shut the motor off, started it back up and after a minute the alarm would go off again and “WF” would flash, this happened a several more times then quit. After the alarm and”WF” problem occured the error described above went away as did the question marks. Does any one have insight to what the problem may be. It doesnt appear that I can get the picture to upload, but if you go to my profile photos you can see it there.Last edited by SeaPointBakers on June 1st, 2012, 6:20 pm, edited 2 times in total.
.
