Topic: best prop for a 99 classic??

This topic has 3 replies, 3 voices, and was last updated 16 years, 10 months ago by gasaxe.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
August 1, 2009 at 11:51 pm #344289

gasaxe
Participant

i have a new to me 99 classic dual console with a 200 efi. I believe its the 2.5. It came with a powertech 25p prop. This is my first fiberglass type bass boat and am not sure of performance. It seems to have a decent holeshot and runs in the mid to upper 60s with a FULL load 2 big guys full livewell and 3/4 tank of fuel. I have played with the jackplate a little but really havent noticed much change. It was set at aprx. 8 inches below the pad. i have had it as high as 4″ with no noticeable gain maybe a bit slower out of the hole. The fastest ive seen is 68 gps with a lite load. Any suggestions on what the best prop is for this combo?? I have looked through some old post, didnt find much relating specifically to this year model.

August 2, 2009 at 12:30 am #344304

Bass Cat Boats
Keymaster

We used a 25 Tempest in those models usually, some liked a Trophy personally. Though we would try a 24 Fury today.

August 2, 2009 at 5:56 am #344316

oldtimer57
Participant

Also you might not yet have reached a decent motor height. 8″ below the pad, if that is an accurate measurement, is _Wayyyy_ down there. 4″ is getting close to home. But motor height and prop interact significantly. Some props will not run high. Not enough cup, poor blade shape, poor rake, etc. Dont know enough about powertech to say anything useful.2008 Pantera Classic2014 Mercury Pro XS 200

August 2, 2009 at 1:36 pm #344326

gasaxe
Participant

i measure the prop shaft centerline in relation to the pad on the boat. Used a straight edge (level) extended back towards the motor. From what ive read on here i thought that 8 was low so thats why i started moving it up. I havent seen a noticeable change other than maybe a bit faster out of the hole with it lower.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register