Topic: Small stainless cup holders

This topic has 6 replies, 5 voices, and was last updated 7 years, 11 months ago by Carl W.

Viewing 7 posts - 1 through 7 (of 7 total)

Author

Posts
November 7, 2017 at 9:21 pm #387624

Bearkat
Participant

I need to replace a couple of my cup holders and would like to go with stainless. The new ones offered by BCB are too large for my boat. I need the small ones that fit a 2-7/8″ hole. Does anyone know where I can find theses?

November 8, 2017 at 4:31 pm #387627

Bass Cat Boats
Keymaster

Ive been looking for something similar. Hard to find the 2-7/8″ size in SS. Im searching for one to replace mine. The small one in the front of my Sabre FTD got converted to a tool holder using a piece of Pelican case punch-out foam. Holds a pair of needle nose pliers and a Boomerang line cutter. Too small for much else.

November 8, 2017 at 6:19 pm #387630

Bass Cat Boats
Keymaster

Good afternoon guys,I got with our parts department to see if we can possibly order these from our current supplier and they are not available to us. We even tried to go step further and we were unable to locate them anywhere from any distributor online. We do offer the smaller size in plastic, just not in SS.BCB

November 8, 2017 at 10:14 pm #387633

catdude28
Participant

The cup holders made for poker tables may work. Their internal diameter is 2 3/4 inches. If they dont quite friction fit, then a drop of silicon on the lip should work.

November 9, 2017 at 12:10 am #387636

Redngoo
Participant

catdude28 wrote:The cup holders made for poker tables may work. Their internal diameter is 2 3/4 inches. If they dont quite friction fit, then a drop of silicon on the lip should work. Ive looked at the pool table cups several times myself. They can be found in different colors as well. Even with led lights if one elects this option. As far as the 2.750″ size thats only .0625″ to a side difference . As said a dab of silicone urethane will cure that. The only other thing would be a few drain holes would be needed. They are also available in aluminun or stainless.

November 10, 2017 at 6:46 pm #387639

Bearkat
Participant

Thank your looking into the cup holders BCB. Ill give the ones for poker tables a look.

July 16, 2018 at 2:25 pm #387642

Carl W
Participant

Stupid question. How does one widen the hole to change out the cup holders? I have two plastic ones in my 2010 Panteria IV but, they are too small for a Yeti which I like to take along for a morning of fishing.
Author

Posts

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic. Login Register