Owner's Board

Help with upgrade fuel lines for 03 Sabre with 150 vmax

This topic has 3 replies, 2 voices, and was last updated 14 years, 11 months ago by Bass Cat Boats.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
July 15, 2011 at 4:13 am #407989

hntnfsh00
Participant

I have a 03 Sabre with a 150 Carb vmax. I have the upgrade kit from basscat, fuel line and primer bulb. Do i run that line all the way to the fuel filter on the motor or do I stop at the coupling right before the motor where the yamaha line and the basscat line meet. I also am putting in the yamaha water seperator filter (10 micron) there isnt much room to mount it. The best place i found is on the port sidewall next to the battery, any suggestions on that would be great also. Thanks Aaron

July 15, 2011 at 4:30 am #407991

Bass Cat Boats
Keymaster

The best is to replace all from the BCB line as they are not ethanol resistant. The filter may go in the splash well support behind the lid and above the sump underneath there.

July 15, 2011 at 4:37 am #407993

Bass Cat Boats
Keymaster

ok just the bcb line and not the yamaha line going into the motor?

July 15, 2011 at 11:15 am #407995

Bass Cat Boats
Keymaster

They should be stamped A1 or A2 to be BCB lines that are resistant.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats