Owner's Board

Removing epoxied transducer from hull..

This topic has 4 replies, 2 voices, and was last updated 13 years ago by Bass Cat Boats.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
May 22, 2013 at 4:16 pm #434360

brnzbaklvr
Participant

I may have to remove a Factory/dealer installed transducer from the bilge of my Puma..It has the black Epoxy holding it down. I have read that guys just hit them with a hammer to break them free but that makes me a little nervous, how do you guys get them out….?? Would it be better for me to cut it out with a cut off wheel in a die grinder??What is the best tool to sand out the epoxy after removal of the TD?? I have a dremel and a Dewalt electric hand grinder…I also have a Pneumatic die grinder…..Thanks for any info

May 22, 2013 at 4:33 pm #434361

Bass Cat Boats
Keymaster

I tried knocking mine off with a brass hammer, and a dead blow. wouldnt budge. So I put my 4X Rivet gun on it and came off real quick. Sanded the old epoxy down with a high speed 90 degree air grinder with a sanding disk.

May 22, 2013 at 4:36 pm #434362

Bass Cat Boats
Keymaster

We bust them out easily. BCB does not use epoxy, though a fiber filled polyester resin putty. It is very (very) hard though will pop out with a solid hammer blow.

May 23, 2013 at 12:35 am #434363

Bass Cat Boats
Keymaster

Where would I find that resin bcb uses?

May 23, 2013 at 1:39 am #434364

Bass Cat Boats
Keymaster

They have it in house and it is made for their production only. They may be able to send it in a can, though 24 epoxy works too.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats