Owner's Board

DURA PRO 2 PURPLE WIRE

This topic has 2 replies, 2 voices, and was last updated 6 years, 5 months ago by BIGCATTER.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
December 18, 2019 at 3:01 pm #680496

BIGCATTER
Participant

Well , folks , I like to think I can figure just about anything out , but I can find no reference to a purple wire in one of the 3 charging leads on a dura pro 2 on-board charger . – It’s really a moot point since the charger isn’t working right and is being replaced by a Noco , but I need to know why said purple wire was tapped into the engine harness on this boat . — I gots to know !! — Any and all theories and / or explanations will be gratefully accepted . — Thank you in advance for your replies . — Hoss

December 18, 2019 at 3:42 pm #680497

5 keepers
Participant

Cranking Battery Cable
The cable assembly designated for the engine starting battery is unique in that in addition to the
Red (+) and Black (-) wires, there is a purple wire that must be attached to a 12 Volt source,
which is switched on and off by the engine ignition key switch. Use the supplied quick connector
to attach the purple wire to any key activated 12 Volt source. It is important to note that the
“charge on the run” circuitry will not operate unless the purple wire is connected to a 12 Volt
source.

December 19, 2019 at 12:40 pm #680505

BIGCATTER
Participant

Thank you for the information . – I can sleep now .
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats