Owner's Board

Humminbird GPS / Heading Sensor placement

This topic has 4 replies, 4 voices, and was last updated 5 years, 10 months ago by Dwayne.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
July 28, 2020 at 7:04 am #692044

BCCougar29
Participant

I am installing a mega 360 on my Cougar, and need some advice on where to mount a Humminbird GPS / heading sensor?

The Ultrex heading sensor is installed on the port side bow from the factory, but I do not have room to add a second on there.

I was thinking about on the port side bow deck near the volt gauge, but not sure if that is a good spot.

Any ideas are appreciated.

July 28, 2020 at 9:58 am #692048

fishndav
Participant

July 29, 2020 at 5:10 am #692108

BCCougar29
Participant

Is that installed in the cup holder?

That looks good to me…..any advice on how you ran the wire and secured the puck?

July 30, 2020 at 8:02 am #692127

tjbubba
Participant

I went to lowe’s and bought a plastic sink drain and painted it black and siliconed it in where the cup holder was (remove the cup holder)

Run the wires thru the drain hole done

August 5, 2020 at 4:26 am #692274

Dwayne
Participant

It’s bluetooth so you can place it anywhere on the boat.

The compass on my PIV is on the stern. As long as it is aligned with the center line of the boat your good to go.

Enjoy
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats