Made my own for my 2008 Pantera Classic using .25 inch plywood covered by indoor/outdoor carpet attached with carpet tape and hot glue. The front piece is 2 pieces of plywood attached at the top to a piece of 3/4″ stock 1.5″ wide. Drill holes sized to accept golf bag tubes then offset the front one a little toward the inside of the boat because the hull curves in up front. The back one is just the .25″ plywood attached with screws at top and a spacer at bottom to hold it away from back wall of rod box. The rubber grommets for the rear part are available online or maybe from BCB. Carefully measure and pattern both as the reverse of the left side box. Mine works and looks great.
.
