Owner's Board

2009 Cougar and Noco Gen4 charger

This topic has 3 replies, 2 voices, and was last updated 11 years, 3 months ago by dfdpace.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
March 4, 2015 at 9:55 pm #290152

dfdpace
Participant

Ok so heres my dilema. Original charger (or so I am assuming because its a Pro Pak IV) went out. Bought a new Gen 4 Noco to replace it. Went to put the new one in yesterday and its a very tight fit and im a little hesitant about leaving it screwed to the transom because of the angle. My question is has anyone else had this problem and where did you mount the new one and how? Also is there a way to make it work on the transom where its at now?Thanks

March 4, 2015 at 10:33 pm #290153

Bass Cat Boats
Keymaster

Hmm…I replaced a Cul M Rite on my 2009 Cougar with a new Noco last spring. (Actually Sherm did it). It seemed to fit okay. Mine was a three bank charger though.

March 5, 2015 at 12:24 am #290154

Bass Cat Boats
Keymaster

Should have been the same frame size.

March 5, 2015 at 1:27 am #290155

dfdpace
Participant

BCB I will look a little closer but I know the holes do not line up at all. I may try putting some rubber washers behind it so that the motor bolts dont mess with the angle too much.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats