Owner's Board

2013 P IV transducer question

This topic has 5 replies, 3 voices, and was last updated 12 years, 12 months ago by Bass Cat Boats.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
June 20, 2013 at 11:53 pm #328839

BlueDuck
Participant

I ordered my 2013 P-IV wired for a HB- 998 in dash and an ether-neted 788 on the bow. The 788 is connected to a glassed in t-ducer somewhere in the front of the boat? Where does BCB usually install this t-ducer, or is it just connected to the rear one in the hull.Im thinking of running a new t-ducer on the actual trolling motor to be more accurate. Any comments anyone—–BCB. My hull id is BASN3196C313.

June 21, 2013 at 12:26 am #328854

Bass Cat Boats
Keymaster

Mine came with a Hbird ducer glassed into the bow as well, its separate from the one in the rear sump.

June 21, 2013 at 12:34 am #328877

Bass Cat Boats
Keymaster

That hull transducer is located in the center of the hull about half way between the seats and the bow. It is connected to the bow unit only.

June 21, 2013 at 12:45 am #328894

LB1202
Participant

Run a separate transducer on the tm. This will give you ability to vertical jig, drop shot, etc. get the one designed for the tm its a round puck style that uses a clamp.

June 21, 2013 at 12:55 am #328915

Bass Cat Boats
Keymaster

LB—Ive got one, just wanted to check before I did anything.BCB— Thanks for the reply, need to decide if I want the accuracy.

June 21, 2013 at 1:54 am #328932

Bass Cat Boats
Keymaster

Trolling motor mounted transducers are an option in the build process. Some like them for deep water though some like internal for shallow water.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats