Hey all,Going to order a couple Stern Sticks and need mounting brackets made for them. As the title says I have a 5.5″ CMC power lift jack plate on my 92 Pantera 2 thats in storage. I can get measurements this weekend but would like to get the order in ASAP so I was wondering if anyone can provide me with width between the bolts on the plate as well as the diameter of the bolts. If possible I also need to know how much rise and setback Id need for the model of boat. Not sure if anyone can help, but it would be great if you can!Thanks guys…
I measured one not on the boat, the bolt holes are 13 inches center to center, and are 1/2 inch in diameter Last edited by Jimpantera2 on April 1st, 2013, 10:41 pm, edited 1 time in total.
I need to know the spacing on the bolts on the side that you loosen to adjust the plate, from center to center. And if you can get at it I also need to know how thick those same bolts are.On a side note, does anyone know why power pole doesnt make jack plate mounts for these plates? Is there an issue with mounting to them? Is it possible I need a mount between the motor and plate?
Thanks for the responses guys. With such different numbers I should probably take a drive and make sure I get the ones correct for my specific application. I do appreciate the time you guys took to get them for me though. Cheers!
Author
Posts
Viewing 5 posts - 1 through 5 (of 5 total)
You must be logged in to reply to this topic. LoginRegister
.
