Topic: Automatic Bilge Wiring Schematic?

This topic has 9 replies, 3 voices, and was last updated 11 years, 2 months ago by Bass Cat Boats.

Viewing 10 posts - 1 through 10 (of 10 total)

Author

Posts
April 1, 2015 at 11:40 pm #288932

panterabam
Participant

2006 PIV……turn on auto bilge and the pump stays on with the “new sensor” sitting level….would like to troubleshoot, is there a schematic I can download?Tks

April 2, 2015 at 3:35 am #288933

clownshoes
Participant

I checked mine the other day. In mine theres a ball that rolls around on the inside to activate the circuit I believe. I would lift the switch To the pump and make sure it wasnt stuck in a position to make it run all the time? Then Id just unscrew the float portion and replace if I couldnt get that to get it fixed.C.O.D. Jr. III

April 2, 2015 at 9:59 pm #288934

Bass Cat Boats
Keymaster

thanks, but the float is brand new….no worky when installed, pump wont shut off….I checked the float with an ohmmeter, working as it should, i.e circuit opens and shorts when float is up and down…

April 3, 2015 at 3:29 am #288935

Bass Cat Boats
Keymaster

He relay must be stuck

April 4, 2015 at 2:31 pm #288936

Bass Cat Boats
Keymaster

where is the relay for it located?

April 5, 2015 at 12:40 am #288937

Bass Cat Boats
Keymaster

The Relay is in the ATen unit. If it works through manual and auto to off, then something else is up. We have hardly seen a relay stick.

April 5, 2015 at 12:41 am #288938

Bass Cat Boats
Keymaster

panterabam wrote:where is the relay for it located?The relay is an integral part of the touch pad. I doubt there is anything you can do to repair it but try unplugging your touch pad and then after a few minutes plug it back in. Sometimes this resets things and it just might work for you. Everyone should believe in something. I believe Ill just go fishing!

April 5, 2015 at 12:51 am #288939

Bass Cat Boats
Keymaster

You can tap the back of the units relays as the Sky relays are easily seen.

April 5, 2015 at 12:22 pm #288940

Bass Cat Boats
Keymaster

thanks guys

April 5, 2015 at 2:47 pm #288941

Bass Cat Boats
Keymaster

The float does not use any power and should only have 5 volts in the wiring due to the dash operating on 5 volts. There is no 12 volts feeding through the switch you are calling a sensor. Connecting or disconnecting the two wires should kill the auto function and double check that the relay failed.
Author

Posts

Viewing 10 posts - 1 through 10 (of 10 total)

You must be logged in to reply to this topic. Login Register