Best way to run Ethernet to bow?

Theres already a hole there. Run it through the top of the drivers rod locker and zip tie.

On my Sabre I removed the clamshell and ran a fish tape thru the cable hole in the pedal well up front, pulled thru the drivers side rod box and poked thru the opening between the console and the outside of the hull. If youre LSS-2 in mounted the rod box you stop short of puling it thru to the console. Tape on the Ethernet cable and slowly pull back thru to the front. Wired tied the cable to the existing wires that are run thru the factory installed tubing (Ethernet cable ends are too big to fit thru the tubing). Took 15 minutes total.Last edited by RazorCat on September 10th, 2013, 1:33 am, edited 2 times in total.

Just got through the rod box on that side and route it over the console petition in the corner of the gunnel. Some brands foam the gunnels though BCB does not and it is accessible easily. If water is headed to the gunnels we have a major problem and foam in the upper deckis too late to be buoyant. You should have ways to anchor it and the rub rail can have fasteners placed under the trim strip through the side if the rub rail itself should you need it.

GRR884 wrote:Here you go…http://basscatowners.yuku.com/topic/261 … onsole-BowGary, I know this is one of many reasons why you own a BassCat. Thats so you can go to your barn cave and do these fun upgrades. Thanks for sharing and sure glad youre on the BassCat team to help others!!! Thats a major kudos right there brother.