Compartment Lights – Need Pictures

Kent, they rivet with Avdel moisture resistant rivets, Under the box lips outside in the hinge area. You can out them about anywhere on that flat underside. Place them to where the switch fits on the brace toward the rear and the light wire stub does not have to be lengthened if you can get the switch and light string in that range.

We have them and Parts could drop them to you in an envelope.

Kent, just to give you another option…….What I did was to place a small amount of resin on each rivet after the job was complete. Just leave the lids open until dry and youre good to go. You cant go wrong with BCB original manufacturers parts though. Good luck with your project.Everyone should believe in something. I believe Ill just go fishing!

No need to do that. Simply decide where to install the first light in the string, mark it and then stretch the string out with very little slack, mark the other spots. This will have to be done from inside of the box. You will notice a “flat spot” between the lip of the box and where it then goes upward as the top cap. Drill and place your string toward the back of this “flat spot”. Then drill each hole from inside the box with 1/8″ bit and then install rivets from inside the box. Heres a tip…..sacrifice a drill bit by breaking it into a small bit so that when you put it into your drill it will be very short allowing more room for your drill inside the box. Is there a dealer close to you where you can go see one with lights installed? I wont have a digital camera until Govt. sends me that economic stimulus check. Gotta help the economy you know.Everyone should believe in something. I believe Ill just go fishing!

which box do you want pictures of. Ill go take them, of my compartments. oops, granddaughter took my camera for graduation party. SORRY I spoke to soon. I can do it in the morning.Last edited by customcityjim on May 4th, 2008, 2:23 am, edited 1 time in total.