Topic: HOME WORK HOtline

This topic has 3 replies, 4 voices, and was last updated 13 years, 9 months ago by HOGDAD67.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
August 22, 2012 at 12:10 am #342789

jbassertn
Participant

Ive had my 08 puma sense feb 2012 great boat Ive had other brands before this and can say quality of this boat ranks on top great ride this owners board is what made my final decision to purchase a BassCat Im on here all the time going thru the FAQ and reading the new ones !! but Im raising my hand or calling the home work hotline on this one its time to grease my detwiller jack plate and yes the fittings have rotated to the point where i cant get through the side hole to reach them thinking about putting a 90 deg on them to grease it but still want to rotate them back to correct my question is if i do grease them 1st will this help turn or not and from the FAQ it says lift on motor use channel locks to turn can you get the channel to it or is there a better way QUESTION #2 both live well lights are out the amber trl lights so i need to replace would you replace with stock or go with after market like blue water? and would you put below the water line like at the bottom ill say thanks in advance and thank you BassCat for a site like this so we all can learn and communicate and yes it does sell boats for ya.

August 22, 2012 at 12:34 am #342809

Bass Cat Boats
Keymaster

Thank you for our comments. The lighting we would leave above water line and the jack plate towel over the ram cylinder and twist it as noted. The rest is opinion on Bluewater. Mike has built a following, though he just handles Chinese LED lighting and there are other lighting set out there. If your looking for LED then you can get LED in Wesbar which are in the well now. We just dont carry the Wesbar LED lights.

August 22, 2012 at 1:55 am #342826

VTBassCat
Participant

To add a bit to the jackplate greasing…As you turn the cylinders, have someone lift up on the motor. Not pick it up, just enough to get the weight off the plate. The cylinders will turn very easily that way. No need to use a 90, just turn them back into position with channel locks and a towel, as BCB says, and then grease away.Bill Spence St. Albans, VT [url=mailto:billspence@yahoo.com]billspence@yahoo.com[/url] http://www.twinstatebassin.com Bass Cat Boats http://www.basscat.com Vexilar Marine Electronics http://www.vexilar.com

August 22, 2012 at 12:37 pm #342844

HOGDAD67
Participant

You can get a flex (rubber) hose for your grease gun.That will allow you to access zerts from different angles.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register