Owner's Board

how much trouble we talking?

This topic has 3 replies, 3 voices, and was last updated 18 years, 1 month ago by Bass Cat Boats.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
April 20, 2008 at 2:44 am #324470

zoomCatD6R
Participant

Getting a Lowrance 527 unit to put at the wheel, and going to put my X96 up front tp replace my X75, How much trouble is this going to be to change out? I know from looking its crazy tough to figure out a way to get cords pulled on the P3, if even possible..?? . thanks..

April 20, 2008 at 2:47 am #324489

PhilAddison
Participant

shouldnt be that big of a deal. get a fish tape, snake, or whatever you call and that will help you run the wires from the bilge to the console. another hand to help run the wires down the side is also a big help, but not necessary.

April 20, 2008 at 10:37 am #324508

Bass Cat Boats
Keymaster

You can also tape the new wires to the ones you are replacing. When you pull out the old ones, just pull in the new ones at the same time. Good Luck Joey Watts

April 20, 2008 at 10:50 am #324524

Bass Cat Boats
Keymaster

It will require a new puck transducer and verifying the dash cut out. That will be the worst part of it. The wire routing is not too bad if you use the cowl vent.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats