Installation Instructions – Running Cable from Console to Bow

Been some requests the past year or so on running a cable from the drivers console to the bow. I thought this might help out some BCB folks and later BCB could put it the FAQs.Easy installation instructions for running a cable from under the drivers console to the bow. Approximate time was 20 minutes and boat used was 2012 P-II. Step 1. Start here by removing wire cover (clam shell) Run a snake, or a heavy gauge piece of wire the direction of the arrow. You can push it with your left arm while your right arm is in the starboard side rod box feeling for it. Once the snake is pulled thru I then attached a piece of string to the snake and then pulled it back thru until the string was back thru the clam shell opening. Step 2. Follow instructions in picture below. Step 3. Secure cable to existing wires in starboard rod box using zip ties as shown below. Step 4. Push Cable thru factory opening located in the corner of the starboard rod box as show below. Step 5. Finish by pulling cable thru the factory opening under drivers console. The same snake may be used but I didn’t need it in my installation. Hopes this helps a few folks out