Topic: length of puma and 250 proxs trimmed down?

This topic has 5 replies, 6 voices, and was last updated 13 years, 8 months ago by JSLAW.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
September 19, 2012 at 2:35 am #404449

grimmjsg
Participant

Does anyone.know.the.length.of.a.2012 puma.and.250.xs.trimmed.down.I am.trying.to.see.if.my new.ride.will.fit.in.my garage.?

September 19, 2012 at 2:38 am #404453

PhilAddison
Participant

i would guess about 23. the posted lengths are at basscat.com

September 19, 2012 at 1:16 pm #404456

kent7351
Participant

23 with the swing away tongue.http://www.basscat.com/pumaftd.html

September 20, 2012 at 11:46 pm #404459

jbassertn
Participant

22 ft to breakaway and 25 ft with tongue out is what i have with a 08 puma dont be leave the length has change and thats running the tape straight down the middle on the floor my garage is 27 deep and can just walk around it bcb show 256 and 23Last edited by jbassertn on September 20th, 2012, 11:49 pm, edited 1 time in total.

September 21, 2012 at 12:45 pm #404462

JohnM17
Participant

My garage is 23 deep and a Cougar needs a slight angle to go in with the tongue broke. The TM sticks out further than the tongue, at least it does with a MG. Running a 6″ JP and a 225 Merc which should be the same size as a 250. Every garage is a little different, that measurement is motor tucked.

September 22, 2012 at 12:47 am #404465

JSLAW
Participant

My Garage is 2311″ and it uses every bit of that, I have roughly 2.5 inches from the rear of the lower unit tucked down level, and right at 2 inches from the tip of the troller to the garage door. It is tight but it does fit.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic. Login Register