Need Advice

I doubt slidemaster plates are loose. I have seen far more loose motor/jackplate jackplate/transom screws. First thing id do is see whats loose back there and tighten.If nothing is loose then the next q is how long have u had the boat? Have seen a few that looked more tilted than they actually were.Last edited by clownshoes on December 4th, 2011, 10:11 pm, edited 1 time in total.C.O.D. Jr. III

Best thing to try is first mark the location with a pencil of where the jack plate is set. Then loosen both sides of the plate and lower the plate about 1/2 inch. From there, begin to raise back to the level mark with the pencil. The threads when loaded sometimes cannot get enough slack to even on both sides when lowered, but they can re allign themselves when raising. Good Luck

BCB is correct. I doubt Sherm would do that now, but I guess it wouldnt hurt to ask. He has Harleys of his own and rides whenever he gets time.