Owner's Board

Need help chasing a transducer wire.

This topic has 1 reply, 2 voices, and was last updated 5 years, 5 months ago by porkybass.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
January 7, 2021 at 8:14 pm #695469

Kissimmeebasser
Participant

I need some advice on chasing the SI transducer wire from the jackplate to the adapter on a 2019 Caracal. I am trying to upgrade all my electronics to Helix G4N models and having a terrible time getting to the connector on the splitter at the console. Has anyone done this and is it an option to get to that connector if I remove the throttle/shifter plate and try to get it there?

Thanks in advance for any advice y’all have.

January 11, 2021 at 8:24 am #695586

porkybass
Participant

The “y” cable (splitter) itself is not long so usually it tied up under the dash somewhere. If not it probably got pushed into the side hole under the dash where all your wiring comes out and not in there very far! If you can’t get it to come out by gently pulling it thru then yes you can remove the 4 screws holding the throttle/shifter plate in place to get your arm back there and find the y cable but it will be more difficult to get both arms In there to unplug the trasducer wire in there so you will most likely have to push it back out the hole under the dash so you can unplug it
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats