Topic: Power pole install pictures

This topic has 5 replies, 4 voices, and was last updated 13 years, 7 months ago by Tony Steinfeld.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
October 22, 2012 at 9:59 pm #347065

Tony Steinfeld
Participant

Im going to be installing dual power poles into my 06 Puma this weekend and wondered if anyone here has done the install to see how the pumps are located. Right now, I have only the space in between my batteries to mount a bracket and then mount my pumps. Please provide a picture if possible or any ideas if theres a better location to mount them on. I have 4 batteries in the rear section with 2 per side and approximately 6-8 inch space between each pair.If you cant convince them, confuse them.

October 22, 2012 at 10:05 pm #347081

NCStatefan
Participant

I have seen them mounted to the seat pedestal utilizing a custom bracket. That would be a good option.

October 22, 2012 at 10:57 pm #347100

Tony Steinfeld
Participant

I currently have a single power pole mounted on the pedestal in the battery compartment, but need to figure out a way to mount 2 pumps in there and theres not enough room to mount them on top of each other. Last edited by Tony Steinfeld on October 22nd, 2012, 11:02 pm, edited 1 time in total.If you cant convince them, confuse them.

October 23, 2012 at 12:27 am #347114

JSLAW
Participant

Clean that bilge out!

October 23, 2012 at 1:31 pm #347123

Joey
Participant

What I did when I went to 2 pumps, is put one back where it was and I mounted the other on my seat post between the livewells. I used a 1 1/2″ muffler clamp from a local parts store on the bracket. It has worked out awesome! Still have plenty of room to get to the oil and can remove a battery with ease if needed.

October 23, 2012 at 2:05 pm #347141

Tony Steinfeld
Participant

Thanks Joey. I might have a way I can mount the second pump on 2 of the threaded rods that hold down the battery tray. I have some .100 sheet aluminum i can bend almost like a C channel and mount it to the 2 rods top and bottom and secure it down with the tray nuts and have the pump bolted directly to that and one to the pedestal pole. Ill take some pictures when all is done and put them up for others to see.If you cant convince them, confuse them.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic. Login Register