Topic: PowerPoles – Pump installation

This topic has 4 replies, 3 voices, and was last updated 9 years, 1 month ago by kent7351.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
April 30, 2017 at 1:46 pm #278523

MikeLoughlin
Participant

I have an 05 Puma that I recently upgraded the trolling motor on to a 36volt 101 Fortrex. Ive recently ordered 2 x 8 PowerPole Pro Series IIs for my boat as well. I have two questions for fellow BassCat owners 1)Where is everyone else isnstalling their pumps for the Power-Poles on their older Cats if you already have 4 batteries + the oil container (Please post pics if you can) 2) My boat came with a Detwiller jack-plate, so im wondering which mounts/brackets are you purchasing for your poles?thanks!Mike

April 30, 2017 at 3:13 pm #278524

Bass Cat Boats
Keymaster

In 2005 Power Poles were not around to be installed, so no one had any way to think abut room for pumps before these were a hot item. There is a the post for the seat pedestal and a board over the sump most are doing. On some Pumas we have seen them on the backof the storages also.

May 1, 2017 at 6:34 pm #278525

Bass Cat Boats
Keymaster

If they are putting a board over the sump then where does the oil container go? Are there any pictures that can be shared or the link?

May 2, 2017 at 12:28 pm #278526

Bass Cat Boats
Keymaster

Since its an application after most Puma models were out of our facility we dont have any images on the install. Someone will bust on here with some help.The rear seat pedestal with a muffler clamp should handle one, and you might be able to build a strap bracket to handle both there.

May 4, 2017 at 2:38 pm #278527

kent7351
Participant

Here are a few ideas for you:
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register