Topic: Pro trim install on 97 jag with 97 Johnson

This topic has 5 replies, 2 voices, and was last updated 10 years, 6 months ago by dcpuma.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
November 21, 2015 at 11:12 pm #424812

dcpuma
Participant

Wondering if anyone knows what wires to look for under the dashboard. Ive looked in faqs section and didnt find it.

November 22, 2015 at 1:16 am #424814

Bass Cat Boats
Keymaster

When I removed the wheel there is a metal extension ring on the shaft which is also part of the shaft. How does this remove for the install? Any help would be great.

November 22, 2015 at 3:15 pm #424816

Bass Cat Boats
Keymaster

You unbolted the wheel from the hub using the 6 cap screws. These are not how you remove the wheel, the hub itself has one nut and a puller or other method (FAQ) will remove the wheel hub. The cap screws should not be removed. Your looking for three wires on the engine harness, purple(+), green(up) and blue(down). These should be in the actual engine harness where these enter the control box and will be extended to the bow switches with 3 added wires. BCB

November 22, 2015 at 3:48 pm #424818

Bass Cat Boats
Keymaster

I remember 20 years ago doing that on a 200 Venom, except I was adding the two button switch on the wheel. I recall that the switch came with a couple of feet of the coded wire, and all I had to do was tap into the coloured wiring just as BCB suggested above. It actually was pretty simple. I also added floor trim switches on that one.

November 22, 2015 at 4:17 pm #424820

Bass Cat Boats
Keymaster

And Up goes on the bottom of the switch, while Down goes on the top.

November 22, 2015 at 6:26 pm #424822

dcpuma
Participant

Ok guys I got it all done. Special thanks to Stuart who I am fortunate enough to have his phone number. He helped me last night.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic. Login Register