Topic: Prop to Pad

This topic has 6 replies, 6 voices, and was last updated 8 years, 10 months ago by dro.

Viewing 7 posts - 1 through 7 (of 7 total)

Author

Posts
March 23, 2010 at 12:33 am #279091

4doorcat
Participant

Thats how I always measure my prop to pad. On my pII Im 4″ below. How does your boat peform? If you are comfortable with the way it performs now why change it?

March 23, 2010 at 1:39 am #279092

dro
Participant

it preforms well i just always hit the rev limiter

March 23, 2010 at 2:33 am #279093

dro
Participant

how do i measure my jackplate height

July 19, 2017 at 9:45 pm #265152

BamaCat
Participant

i was outside an just figured i would measure to see how much my prop below pad i have a 06 Sabre with jackplate maybe i measured it wrong at least i hope i did cause i come up with 8 1/4 below pad i leveled the pad an measured from ground to pad then leveled motor an measured from ground to middle of shaft am i measuring it right.

July 19, 2017 at 10:40 pm #265153

Dwayne
Participant

Water is warm enough. Grab some wrenches find a beach where you can make adjustments and play around. One note is that I would load the boat and set it up. Fill livewells and fuel tanks and have a passenger on board, then youll be able to get it set it up for the times you need it… on you way back to weigh in that monster bag. :-)Practice Angling CPRCatchPictureRelease2010 PIV 200SHO

July 20, 2017 at 2:25 am #265154

Redngoo
Participant

Furys run little deeper. Since you raised it and it hadnt help. Id lower it back down flush. Then work down from there since bcb usually sets them flush. Im guesing all the plugs are out?. That 25 fury should be a good prop for you. Maybe some of the speed guys will cue in2013 PANTERA 2MERCURY 200 PRO XSMINNKOTA 80LB FORTREX25 fury

July 21, 2017 at 1:06 am #265155

Goody81
Participant

following also still having issues with my 12 cougar
Author

Posts

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic. Login Register