Topic: Pump out | Bass Cat

This topic has 8 replies, 5 voices, and was last updated 13 years, 10 months ago by JEH in La.

Viewing 9 posts - 1 through 9 (of 9 total)

Author

Posts
November 14, 2007 at 7:37 pm #362843

Bama Spotman
Participant

what to do next (Your vote has been cast.)Total votes: 3 help, send response 3(100%) You may select 1 option2010 PUMA, My pump out on my live well panel lights up, but no pump out, switched pumps still nothing, put pump out pump in differernt spot works fine. All other lights and pumps working, looks like a sealled circut under the dash, so no loose wires here. Whats my next step guys?

November 14, 2007 at 8:59 pm #362845

Bass Cat Boats
Keymaster

You can add the outlet and run it off of your accessory switch on the dash board. Simple pump in the lower livewell, fitting outside with a hose in between. No Problem other than running those wires. BCB

January 4, 2012 at 3:38 am #446314

Bass Cat Boats
Keymaster

is the suction line to the pump plugged or have trash in it causing it to cavitate? maybe the discharge of the pump is plugged? have you tried to replace with a known working pump?

January 4, 2012 at 4:04 am #446315

Bass Cat Boats
Keymaster

It also may be the impeller is stripped on the shaft. Try another pump cartridge.

January 4, 2012 at 11:53 am #446316

JPeesy
Participant

PA & BCB, not sure how to clear the line, will remove and inspect, but will replace cartridge first. Thanks for help.JP

January 4, 2012 at 12:41 pm #446317

Bass Cat Boats
Keymaster

remove cartridge and water hose

January 4, 2012 at 1:23 pm #446318

Bass Cat Boats
Keymaster

JP, just insert one of your other bilge pump cartridges in to check that. Easy and no cost involved. Swap em out!

August 11, 2012 at 12:31 pm #461704

clownshoes
Participant

Id trace wires in bilge and find my loose connection. Leave switch on and get out my voltimeter. Im bettin its in the sump. Go on and pull oil resevoir out and likely the stand its on too just to give you a wide berth. Resilicone screws in stand if you pull stand.C.O.D. Jr. III

August 11, 2012 at 5:44 pm #461705

JEH in La
Participant

ward wrote: Id trace wires in bilge and find my loose connection. Leave switch on and get out my voltimeter. Im bettin its in the sump. +1……..Yes you need to know if you have voltage on the connectors. The weakest link in the circuit is the connectors. Unplug the pump and put your voltmeter on the connectors and switch on and off, on and off. You should see the voltage come and go. If everything you say is true then you might not see voltage there. You could have a bad connection in the immediate wiring. Anything going back from there is probably a call to BCB for assistance.Just thought of something….I have a Classic and the pumpout switch has a circuit breaker by the switch. Is yours not the same? Make sure its not just a tripped breaker. Last edited by JEH in La on August 11th, 2012, 5:49 pm, edited 1 time in total.Everyone should believe in something. I believe Ill just go fishing!
Author

Posts

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic. Login Register