Owner's Board

reel protector pad installation

This topic has 4 replies, 3 voices, and was last updated 12 years, 1 month ago by Bass Cat Boats.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
April 30, 2014 at 12:36 am #343202

bazcat
Participant

I ordered the reel protector padding for my cougar and it came in 3 pieces. Does anyone have a picture of how they install, I know the big piece has to be positioned above the boat capacity plackard. The long narrow piece obviously is for where the rods lay but unsure where the small 4×5 retangular piece should go. Any help would be greatly appreciated!

April 30, 2014 at 6:26 pm #343218

bazcat
Participant

Nobody else add this to their boats. I thought it would be a neat addition to keep fishing partners reels from scratching the fiberglass.

April 30, 2014 at 11:32 pm #343232

jbassertn
Participant

that rectangular piece goes next to the seat where the rods would lay i put the side piece on only have not had a problem does shrink a little but cleans up what kind of problem did you run into

April 30, 2014 at 11:55 pm #343256

Bass Cat Boats
Keymaster

I havent installed it yet so no problems. I figured the long narrow piece would go next to the seat for the rods to lay on. Just couldnt figure out where the small piece fits in. I was kind of hoping basscat boats would chime in on how the 3 pieces went. I guess I will just call the parts department. Thanks again.

May 1, 2014 at 12:37 am #343281

Bass Cat Boats
Keymaster

How about checking the locations in images on the Bass Cat Boats BCB Facebook by Serial Number site.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats