Owner's Board

Removing Bench Seats

This topic has 3 replies, 2 voices, and was last updated 17 years, 5 months ago by TrevorR.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
December 24, 2008 at 1:55 am #422520

TrevorR
Participant

This may be a stupid question. I have a 2000 Sabre and am replacing my carpet. Im trying to remove the part of the seat your back rests on. (I have bench seats.) I noticed one rivet for each seat right below the livewell lid. Are these the only fasteners? I couldnt find any other fasteners. Much thanks for the help. I never paid much attention to these things until I decided to replace my carpet.

December 24, 2008 at 2:18 am #422521

Bass Cat Boats
Keymaster

I thought that they were screwed on instead of rivets, but I may be wrong. Look for small slits in the vinyl around the perimeter of the seat, and there should be screws through those slits. Hope that is right. Others will be along shortly to give other details. Good luck. KentKent Charles 2002 Pantera Classic & 200 Yamaha VMax

December 24, 2008 at 2:23 am #422523

Bass Cat Boats
Keymaster

Take a look around the lower section of the vinyl seat back where the cushions are seated. There will be small incisions that have a square drive screw head in there seated into the foam. The seat mounting is not that neat, though works very well. You may be able to tuck that carpet behind the benches without removal also, that may be simpler. BCB

December 24, 2008 at 2:50 pm #422524

TrevorR
Participant

Thanks. I appreciate it. Ill take a closer look. I couldnt find them the first time around.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats