Topic: trailer bunk repair

This topic has 5 replies, 4 voices, and was last updated 9 years, 6 months ago by oldtimer57.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
December 10, 2016 at 3:54 pm #421722

oldtimer57
Participant

Am working on mine, but with boat on trailer, it is not obvious how the carpet on the two fenders is attached. I bought enough extra carpet from BCB parts to re-cover these as well, but when I looked inside the fender I didnt notice any sort of screws or anything that might be used to hold these on.Anyone replaced that carpet as well? Is it attached to some sort of marine plywood or separate piece of glass or anything???2008 Pantera Classic2014 Mercury Pro XS 200

December 10, 2016 at 5:43 pm #421724

toledobasser
Participant

I believe it is just glued to the fiberglass.Jim EbarbMany, LA (Toledo Bend Lake)2004 Cougar/ 225 OptimaxHumminbird Helix 12 Chirp SI on BalzOut Mount at bowLowrance HDS 7 at bowHumminbird Helix 12 Mega SI on Ram Mount at ConsoleLowrance HDS 8 in dash at console

December 10, 2016 at 6:49 pm #421726

1stinLA
Participant

Just contact cement.

December 10, 2016 at 10:17 pm #421728

oldtimer57
Participant

Thanks, that ought to make it easy enough.2008 Pantera Classic2014 Mercury Pro XS 200

December 16, 2016 at 5:37 pm #421729

CJ
Participant

Oldtimer 57, how did you end up getting the old carpet from the fender??? Thanks

December 16, 2016 at 11:08 pm #421731

oldtimer57
Participant

Sorry, have not started that as of yet. The glue says it needs 72 degrees to properly set and cure. Dont have that at the moment. I may resort to an electric heater in the basement if my wife doesnt shoot me.My intent is to use a spatula-like gasket scraper I have along with some heat to loosen the glue a bit.2008 Pantera Classic2014 Mercury Pro XS 200
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic. Login Register