Owner's Board

Trailer Fender Pad Help

This topic has 4 replies, 4 voices, and was last updated 16 years, 4 months ago by BASSHAWK.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
February 10, 2010 at 3:25 pm #391809

BASSHAWK
Participant

All, I am looking for options to replace the carpet/rubber on the fender steps on my 91 PII single axle trailer. I have been scanning the internet looking for options, but I am coming up blank. Any help with suggestions for the trailer steps would be appreciated. BASSHAWK91 Pantera 2 91 Mariner Mag II 150

February 10, 2010 at 4:36 pm #391814

billius
Participant

Check out the BassCat store. You can buy that mat like material there. I would guess you might have to call parts to get more info maybe. But Im quite postive that BCB has that available.

February 10, 2010 at 4:47 pm #391816

FireIsHot
Participant

They do. Just make sure the surface is clean before you put the new pad on. Corners really need to adhere for it to fit nicely. I use a heat gun, on low setting, to take the old pad off intact, so I can just trace the new one before I cut the material. It comes in a sheet.http://www.basscatstore.com/non-skidrubbermat.aspx

February 10, 2010 at 5:20 pm #391819

dbasketman
Participant

On my old 90 PII i replaced the carpeted step pads with checkered diamond plate aluminum, and loved it !

February 11, 2010 at 1:25 am #391821

BASSHAWK
Participant

Thanks for the help guys. I will give both of these ideas a looksy. BASSHAWK91 Pantera 2 91 Mariner Mag II 150
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic. Login Register

© 2026 Bass Cat Boats