My trim gauge will not go all the way to the lowest position after running some rough water. The motor is all the way down but the gauge stops between 1/2 & 1/4. I do NOT have the smart craft digital gauges. Is there any way to sync these back up?
Nope, just slightly. The trim senders are notorious or failure on analog senders, especially Mercury. Sometimes you can remove them and shim the center in to extend the life a little longer.
Posted this a couple of years ago, it may help a little to make a small adjustmentLast edited by catmantwo on December 1st, 2014, 4:39 am, edited 1 time in total.Your Signature …
Author
Posts
Viewing 3 posts - 1 through 3 (of 3 total)
You must be logged in to reply to this topic. LoginRegister
.
