Topic: Water PSI at zero, but still pumping. Super Dash.

This topic has 9 replies, 2 voices, and was last updated 18 years, 2 months ago by showdawg77.

Viewing 10 posts - 1 through 10 (of 10 total)

Author

Posts
March 30, 2008 at 1:20 am #348156

showdawg77
Participant

While running this morning at the Spring Classic on Lewis Smith, The “Super Dash” blinked off , or went blank, & when it came back on, I showed Zero Water Pressure, & speedo is about 40 mph slow. I would think trash is my problem but the fact that the dash went blank & came back on makes me wonder????? Water pump is pumping strong stream, engine temp never got up. Anyone got any answers??????????????? by the way, its a 2001 Pantera III 200 HP EFI Thanks in advance Bud aka showdawg77

March 30, 2008 at 1:27 am #348160

Bass Cat Boats
Keymaster

Analog to Digital converter is on the fritz… You should have issues with the barometer and the surface and livewell temps also. BCB

March 30, 2008 at 2:22 pm #348164

Bass Cat Boats
Keymaster

Is it repairable????

March 30, 2008 at 6:20 pm #348170

Bass Cat Boats
Keymaster

Check to see if you can recalibrate the dash and we may have the w/p part in house. They only recently ceased repairing BP dashes and we are working in options now.

March 30, 2008 at 8:22 pm #348173

Bass Cat Boats
Keymaster

OK, How do I recalibrate???

March 30, 2008 at 9:06 pm #348178

Bass Cat Boats
Keymaster

Info on the or in the BP manual. The recalibration is listed in the speedometer section and the PDF is in the home page drop down menu tabs.

March 31, 2008 at 12:05 am #348182

showdawg77
Participant

ok, I have all books & manuals, I will take a look. Thanks

April 1, 2008 at 1:42 am #348185

Bass Cat Boats
Keymaster

I have “reset” the dash, there wasnt any issues with the livewell temp, or barometer before and there isnt any now, dash works as it should other than speedo showing slow, & water pressure showing “00” could it be trash?????? Thanks in advance !! Showdawg

April 1, 2008 at 5:04 am #348190

Bass Cat Boats
Keymaster

Did you specifically reset the speedo using the Master Power switch. And yes trash in the pitot could be an issue, though we suspect the sensor on the water pressure.

April 1, 2008 at 10:02 pm #348193

showdawg77
Participant

Yes, I reset the speedo using the “mode” & power switch,.. Like the manual says. Can I replace the water pressure sensor myself??? Funny that I lost em both at the same time. Speedo, & water pressure.. Can any Bass Cat dealer replace my dash with the upgrade? or should I keep what I have ??? Showdawg
Author

Posts

Viewing 10 posts - 1 through 10 (of 10 total)

You must be logged in to reply to this topic. Login Register