Owner's Board

Johncat

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #719963

    Johncat
    Participant

    I wouldn’t deal with them after they  quoted me $15.000 more than 2 other bass cat dealers for the exact same boat. I told them so after they followed up with me a couple months later

    #720466

    Johncat
    Participant

    Hi, how did you install the flo rite, I have the Pantera classic with the same issue

    Thanks

    #720629

    Johncat
    Participant

    Well, I know the definition of capacity, I was looking for clarification on the size of tank that was installed.

    #720630

    Johncat
    Participant

    Thanks for replying, unfortunately I don’t have the hotfoot. I just would have never imagined a boat would be built that , at any point of position of the wheel and throttle , that there would be only 3/4 ” clearance. Thanks God my fingers are on the thin side.

    #720637

    Johncat
    Participant

    Thanks for the replies. I will just have to be careful

    #720767

    Johncat
    Participant

    Hello and thanks for the reply,  have you ever dealt with a chalky like film or stain on a 5 month old boat, this area gets no sun?  Have you ever used hot sauce on a chalky looking spot?   Thanks again.

    #720790

    Johncat
    Participant

    Thanks for the reply,  I  was under the impression that the pressure of the spring insured grease gets to the inner bearing, but if what you say is true, that makes it a lot easier….  Thanks again

    #720791

    Johncat
    Participant

    Ok thanks

    #720839

    Johncat
    Participant

    Thanks,  yeah, I guess you can, now that I think of it . Maybe a rag also.

Viewing 9 posts - 1 through 9 (of 9 total)

Skip to toolbar