[BMac4848]

Bilge??? The regular boat bilge on???

[BMac4848]

Thanks guys!!!!! Got me a job to do when I get home… Had to throw ( catch and release) back cause I didnt want to keep them in there with no water….

[BMac4848]

Are the hull decals domed or flat… I like the way it looks on the boot

[BMac4848]

Cant get the pole out*

[BMac4848]

Look at the 93sv…. It has inland lakes where the 94 has the coast…. Was told that by a Garmin rep

[BMac4848]

Do u still have the 7

[BMac4848]

I dont tournament fish but Im still trying to get wife to understand that I need to upgrade… 2008 graphs work good but new is always better

[BMac4848]

Im still trying to convince her I need this… Why are women so hard headed when we new toys

[BMac4848]

Plant closing for good or for just a period of time

[BMac4848]

Thx Red…. Just bought my 08 Puma a few months ago and still need to buy and fix some things

[BMac4848]

My wife is the one that launches and loads the boat on trailer. She cant back a trailer to save her life but she sure can load the boat. I watch guys try multiple times to get the boat on, then they giggle when they see her in the boat and Im in the truck. I step out and lock boat down and then turn and ask them if they want her to load theirs for them. They seem to be in awe when she hits it first time. Havent had a guy yet take me up on the offer.

[BMac4848]

I am changing from Lowrance to the Helix 7s. Havent done it yet due to I need to get the transducer shields for TM and the Jackplate. Am putting a 7 Si on console and 7Di on bow

[BMac4848]

If it was anything like the center seat I just did on my 08 Puma.. It would help with 2 people as it was a pain by myself. My seat cushion hinges did not match up but the cushion covered the other rivets. If you use the 4 nuts they supply after you drill the hole ( slightly smaller than the nut) then I used a 40 hex head to tighten it into the fiberglass… Just watch out when it starts getting tight — if it is not going all the way down then try to back it out and enlarge the hole some. I had to find an aluminum rivet that fit the existing holes to use in the new hinges.. A regular hand rivet tool will work fine. ( See my seats on this board— Seat replacement)

[BMac4848]

Look up precisionsonar.com too… That have then but more than Sherms

[BMac4848]

OT– Saw my own ramp follies Sunday afternoon at Mill Creek ramp on Sam Rayburn. My niece and I had come in from a lazy Sunday fishing trip and we noticed 2 young ( say around 18) boys and 2 ( around same age) girls loading a Phoenix. They had just backed down trailer when I walked to get truck. They were still trying to load it as I backed down. After they finally got it on the trailer and putting things away, I loaded mine and walked up to put the winch strap on. Thats when 1 of the boys told the other to pull out. Heard a scratching sound and then a loud thud. The Phoenix slid off the trailer and landed on the cement. He forgot to strap the bow down and didnt lift the motor up so the lower unit was dragging and the driver punched to Ford truck to get up the ramp. The 1 boy called his dad who was there in a few minutes. I pulled up to finish tying mine down when the dad came up and asked if I could help push the boat back into the water off the ramp. Didnt stick around to see damage to hull and motor, but could tell good Ole dad was sick to his stomach.

[Author]

Posts