Owner's Board

BryceFontenot

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #674971

    BryceFontenot
    Participant

    Yes sir but I don’t have a dealer around. I bought the boat used in Texas which is 5 hrs away. I was just hoping to get pointed in the right direction. It’s a 2016 and was told still under warranty but not sure how to confirm. I just bought the boat. Any suggestions would be appreciated sir. I’m from Louisiana.

    #674972

    BryceFontenot
    Participant

    Yes sir but I don’t have a dealer around. I bought the boat used in Texas which is 5 hrs away. I was just hoping to get pointed in the right direction. It’s a 2016 and was told still under warranty but not sure how to confirm. I just bought the boat. Any suggestions would be appreciated sir. I’m from Louisiana.

    #674982

    BryceFontenot
    Participant

    Just bought the boat and didn’t know I needed to transfer the warranty. Seller told me dealers went off of the boat serial number and I didn’t need to do anything. It would be about my luck though that the warranty would not cove this or that the warranty wasn’t transferrable. I also have the Minnkota ultrex with the plastic wire housing that’s broken they covered parts under warranty and sent The parts to him and he just mailed them to me.

    #674986

    BryceFontenot
    Participant

    Yes sir it has continuity on both sides.

    #675012

    BryceFontenot
    Participant

    JUST A FOLLOW UP ALL ISSUES ARE NOW RESOLVED! Thank each of you for the help. NOW I NEED TO TRANSFER THE WARRANTY. I CAN NOT STRESS ENOUGH CHECK THE BUSS BAR VERY CLOSE. I CHECKED IT  TWICE AND WAS SURE IT WAS GOOD. UPON FURTHER INSPECTION I FOUND THAT 3 Hot Red wires and 2 black wires located on the bottom left of buss bar on transom were completely burned off. The only reason I know is because they were behind the back battery in a pile of melted rubber. I rewired the 1st one BOTTOM LEFT SINGLE RED (hot)  to 2nd LUG RED WITH A JUMPER  to a 3 rd RED THEN 4th and 5 th were BLACK JUMPERS. NOTE.. CAUSE OF THIS TROUBLE 12v OUTLET PLUG HOT WIRE CAME LOOSE AND FELL ON THE GROUND WIRE SHORTING ALL THIS OUT. With all this burnt CRAP THE engine ran fine , A10 lit up and everything worked except Bilge pumps and Horn. I also had no power to 2nd small panel which controls Security, Acc , Pump In and Out. Now everything works even stuff I didn’t know I had. Lol… I hope this helps anyone who may run into this trouble.  Thank you for the support. God Bless, Bryce Fontenot  Sincerely , a proud BASSCAT owner. 

Viewing 5 posts - 1 through 5 (of 5 total)

Skip to toolbar