[Cougar Brian]

Thanks , I just went to sears yesterday and up-graded all my batteries. I purchase two PM-1 (group 31) for trolling and one PM-2 (group 34) for the cranking. I was mainly looking at the recommended CCA rating when I made that decision. With your advice I’ll just bring the PM-2 back and exchange for the larger one. The PM-1 has plenty of CCA @ 1150 . Did I mention it’s a pain changing batteries out LOL.Brian[font=VERDANA,SANS-SERIF]Diehard Marine Battery, Platinum PM[/font]PM-1 , 75 Lbs. , Group 31 , 1150 CCA ,205 Min RC and 100AHPM-2 , 83 Lbs. , Group 34 , 880 CCA , 135 Min RC and 68 AH

[Cougar Brian]

TroyJust completed a full over haul on my A-60 actuator. Replaced backup solenoid (brakes were engaging in reverse on soft ground) and the master cylinder. Good set of snap ring pliers is all you need just make sure they open wide enough to slide over the end. If you run across any problems let me know. Brian

[Cougar Brian]

Thanks, that gives me enough reason to investigate a little more…..looks like 8 ft. may be a better option

[Cougar Brian]

I have a SlideMaster Jack Plate and used Bracket PKBD-S-2-2 BLK , these are heavy duty brackets

[Cougar Brian]

Mine do the same thing, called PP for assistance and they said the app for droid phones can change the sensitivity setting. I have an IPhone so this won’t help me out. I did notice that changing to a lower speed setting the pumps seam to shut off better when making contact with the bottom. Brian

[Author]

Posts