Owner's Board

CrankNstein.basscatowners

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 18 total)
  • Author
    Posts
  • #361511

    The 8 power poles are well worth the money…I have two of them on my boat and the install is very easy…Backing under a garage should not be an issue. I keep a remote in my truck and as I am backing in the garage I lower them down until the poles clear the door and then raise them back up.

    #326198

    Nice job….Looks like you really mopped up on the two pounders!!

    #390358

    You are correct about turning the speed down. You can turn it down to 20% or less and the interfernce is minimal. But as you know, no one can fish with the motor that low. I dont understand why it would have just started?

    #390365

    The unit is hooked straight to the cranking battery….

    #390370

    Thanks…I will look at that….will that cause the interference that I am getting?

    #363912

    Hey Doug…….how many places do you fish ? And do you EVER catch them ? Lol Thanks for the compliment….Last edited by CrankNstein.basscatowners on September 20th, 2010, 11:37 pm, edited 1 time in total.

    #275035

    You should be able to buff it out with some 3M rubbing compound and a buffer. When you are done put a coat of wax on it…..

    #261106

    I have used both units. I have never had an issue with the Bird coming unplugged in rough water. For side imaging I would go with Bird (No extra cost for SI and alot of places have the 1197 for $1999 right now). For fishing grassy lakes I would also go with the Bird ( The Lowrance locks up alot in grass). For deep structure fishing and “fishing off the graph” I would go with the Lowrance. The lowrance seems to have a crisper picture compared to the Bird. They are both great but decide which one suits your style…

    #258238

    The issue with one is not the holding power. The issue is boat spin in the wind….

    #444120

    I have a set of four in my garage that I will part with…..shoot me an email tm6903@hotmail.com if you are interested….

    #310140

    http://www.impactfishing….onymurray/tonymurray.htm

    #310170

    I do a bunch of business with them. I deal with Gary Wood over there. Great guys.

    #462470

    Who did the anodizing on the Locks?

    #410031

    TTT

    #288442

    I hated to see that happen. Me and my partner helped your dad lift the other trailer off so the damage wasnt worse. I dont think the guy was paying attention at all.

Viewing 15 posts - 1 through 15 (of 18 total)

Skip to toolbar