Owner's Board

bundy150

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 39 total)
  • Author
    Posts
  • #468282

    bundy150
    Participant

    My crossmember is solid with no holes or any mounting fixtures.

    #468285

    bundy150
    Participant

    BCB, boat is a 2006 Pantera 4 and was purchased new a few months ago. No Basscat plate or mounting hardware was on when I took delivery. It was never there.

    #468287

    bundy150
    Participant

    I have sent emails to BCB service(Scott) and my dealer. Nearest dealer is 130mi. away so I’ll do the install myself.

    Thanks,

    Bundy

    #468227

    bundy150
    Participant

    Does anyone have a picture of their jackplate as adjusted on a P4 running a 26P Trophy Plus? Please email to([email protected])

    thanks,
    Bundy

    #468229

    bundy150
    Participant

    Thanks Phil, but I would still like a visual reference as a starting point.

    #468239

    bundy150
    Participant

    When referring to height , are you measuring the inner plate from the front or the rear?

    #304090

    bundy150
    Participant

    Thanks Phil! I checked and found the wires in the bilge as you suggested. Time to get a wire tie and secure them at a higher point.

    #301879

    bundy150
    Participant

    I saw that one bcochran, but you need to have a ladder already on the boat to use it. What I need is a ladder with a small swim platform for the P4. I would also like to find a ladder I could hand on the front deck lip and take it off when I dont need it.

    #301882

    bundy150
    Participant

    Kent, that is exactly what I need.. a ladder that hangs over the side only when needed. The P4 has a large lip around the deck.

    #323592

    bundy150
    Participant

    I rarely run WOT and like the Trophy for midrange performance below 5K RPMS.

    #415778

    bundy150
    Participant

    BTUNE, I agree. It would be nice if some roller company could make these up for BCB owners. Perhaps BCB could look into this and offer them??

    #286429

    bundy150
    Participant

    My Interstate SRM 27s only lasted 8 months. I upgraded to SRM 29s for an additional $40, and they seem to have alot more juice and no issues so far.

    #383948

    bundy150
    Participant

    http://www.golfcow.com/golf/catalog/sea … es&x=8&y=6 Thanks Pantera IV!

    #354474

    bundy150
    Participant

    Have you taken any voltage readings before, after and during charging? This doesnt sound right.

    #319976

    bundy150
    Participant

    Is this a Mercury recall? What motor?

Viewing 15 posts - 1 through 15 (of 39 total)

Skip to toolbar