Owner's Board

Judge

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 23 total)
  • Author
    Posts
  • #414442

    Judge
    Participant

    that was first thing I checked, but the main panel has power to it the pump in panel does not. Check wire blocks and they are snug. Read in the FAQ section that someone had similiar problem and solved it by finding a corroded wire at the terminal block. Where is It?

    #414446

    Judge
    Participant

    Thanks for the input. I located the wire block and sure enough there was one wire that was stiff and corroded. I cut the end off and replaced it and everything is working properly. Thank you BassCat for a removable rear deck lid, made the job much less frustrating.

    #413560

    Judge
    Participant

    DOUGMCGEEP3 wrote:sweet ride judge. Leave them other props alone get a bigger fury and let it ride. One day you and elwood get some time ride on down to Gods country and I will show you the basin if yall can keep up with my ole 225Thanks for the input Doug, she is an amazing boat. I would love to make a trip. Havent fished the basin since law school and my 15 Alumaweld. Ill pin Elwood down on some dates and let you know we will make it happen for sure.

    #414057

    Judge
    Participant

    Bass Cat Boats wrote:Perhaps a seat switch failing.BCBDo you mean a lid not closing tight because it seems the carpet isstill so new that the lids are not completely flush until you step on them. Or is there an actual switch in the seat that warns of something?

    #406818

    Judge
    Participant

    Thanks I for he input guys. I will try those psuggestions and report back. Have in my shop the following:(2) 26p Trophy Plus, (1) 25p Trophy Plus, (1)25p Trophy small hub, (1) 24p Trophy Plus, (1) 23 Trophy Plus, (1) 27 Turbo Ot4 with blowout ring (1) 27 T1 Yamaha. Are any of these good candidates?

    #406821

    Judge
    Participant

    Ran 26 Fury today. Plates flush water temp 82, full load 2 people center tank 3/4 full. 73.7mph @ 5600 rpm very comfortable may could have squeezed a little more but wife said “no mas”

    #354574

    Judge
    Participant

    Thanks for the input. I will try battery connect and terminal block first and let you know

    #279039

    Judge
    Participant

    Tried to book room 3 times, 2 emails and left message by phone, have go no response who did yall call to get room?

    #274268

    Judge
    Participant

    Judge XXLLaELwood L

    #267368

    Judge
    Participant

    Jon,I just removed mine about 3 weeks ago, made it a completely different boat, I love it. Lots more room especially on tournament days. There is no access panel but you can easily find the heads to the bolts inside the rod locker. Mine were covered by carpet so you may have to feel for them by hand then I took craft style blade knife and cut the carpet around the heads to get a socket on them (12mm) I think. Its a 2 man job, so have partner put wrench on nuts under console and remove. The 2 on the side are a little more difficult. You have to reach along the inside of the top cap through the rod box to get a wrench on the bolt heads. The first one is not too bad, the second one is way up there and you need someone with long slender arms to reach (hint: tie wrench to wrist in case you drop). After those 5 bolts out it slips right off. I was told that BassCat applies windshield adhesive to help hold in place and that will have to be cut, but mine had nothing there and came right off. Whole process took 20-30 min. Plugged holes with black door panel plastic plugs from any auto store. Looks great I would recommend. Can be put back on in the same or less time now that I have done once. Minor scratches but a little elbow grease and 3m light rubbing compound they were gonegood luck

    #346442

    Judge
    Participant

    might look at remote control GoLight. It fits in place of navigation lights, 400,000 candle power and has red and green nav lights below the spotlight and remote in water proof baggie. A little pricey but very cool and can move from boat to boat

    #421056

    Judge
    Participant

    any interest in trade for another prop? have 25, 26 trophy plus

    #266272

    Judge
    Participant

    I have 07 Puma with 250 ProXs and I run 26 Fury to 76mph with me and full load @ 6000rpm with right water conditions before I get any significant walking. I think your wheels are to big and your having to give too much trim trying to get Rpms up. Try the fury get trim between 1/4 and 1/2 you should be right with plate set about 1/4 up. Be sure and get to trim slowly. Lots of posts about that set up and about chinewalk in general check FAQ section. Seat Time cures most of that, the lower pitch bigger diameter I thing will help

    #257747

    Judge
    Participant

    For that money you could find a used Shimano Calais digital, she would have to work hard to backlash it (eBay). My son learned on the Bass Pro Qualifier the controls are pretty good and easy to use hard to find a better $99 reel. The Quantum EXO is awesome, very smooth and light $249 she wont get tired of throwing it. Good luck, do whatever it takes to keep her interested. Nothing better than husband wife teams, plus it gets you on the lake a lot more

    #263622

    Judge
    Participant

    Just replaced mine today on 2007 dual axle. Caliper was UFP purchased at local trailer parts store $100

Viewing 15 posts - 1 through 15 (of 23 total)

Skip to toolbar