[jimwhite]

Yes, the picture says it all, thanks! I am going to check out the Gauge position with respect to the Jacking plate position, my bet is that I am out of calibration and that I will need to remove, or loosen the linkage arm to reset the sender. I was suprised to find that in the full up position, the linkage was so straight that it appeared it could have gone either right or left upon retraction of the motor.

[jimwhite]

Thanks, my cranking battery is suspect of longevity and on the list for replacement. I hope that cures the shut off issue. Jim

[jimwhite]

Can you post a picture of this location on the jackplate frame. I like the sound of this location! Also, what does this “shield” look like and where can it be purchased?Thanks!

[jimwhite]

Perfect, Thank you!

[jimwhite]

billius, i am the guy Schodackbassman is referring to. i have 5 claws. i am assuming you have something on your current trailer, what are they? if you wish to trade and put new rubber on your current rims for me, perhaps you can have mine. [email protected]

[jimwhite]

if you can email me a picture of your rims that would be helpful. my tires are good too so i would remount them to your rims. what are 5 claws worth to you?regards;jim

[Author]

Posts