Owner's Board

Markw8859

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 35 total)
  • Author
    Posts
  • #387661

    Markw8859
    Participant

    does it have a swing tongue on trailer2014 Puma FTD 250 XS

    #354228

    Markw8859
    Participant

    non boaters !!!!!!!!!!!!! LOL2014 Puma FTD 250 XS

    #354246

    Markw8859
    Participant

    I used acetone to clean off paint scratch on my van and now it is dull there . what does Bass Cat say? 2014 Puma FTD 250 XS

    #268766

    Markw8859
    Participant

    I m seeing my dealer this Saturday for trading another brand x in, to move up to a BassCat. Will give him the order this Saturday for Puma FTD with 250 Pro XS. I m looking for every ones thoughts on the sunbrella verses the Aqualon travel covers. I travel every spring from Florida to New York, then in the fall back to Florida. Want a good cover that will last and not mess up finish of trailer & boat.2014 Puma FTD 250 XS

    #310583

    Markw8859
    Participant

    My Factory Rep and Dealer just called My 2014 Puma FTD will be ready to pick up Next Thursday!!!!!!!!!!!!! I can t wait to see her !!!!!2014 Puma FTD 250 XS

    #310595

    Markw8859
    Participant

    RC . & Mike W. , How did u apply the pro tec sealer to the bottom of boat? did u have it lifted of trailer or just did not do under bunks? Or do not u apply to bottom?2014 Puma FTD 250 XS

    #268767

    Markw8859
    Participant

    My dealer just called and said my new Puma FTD will b ready this next Thursday! that was fast2014 Puma FTD 250 XS

    #261591

    Markw8859
    Participant

    thanks for all the help2014 Puma FTD 250 XS

    #454803

    Markw8859
    Participant

    Nothing loose, the boot around actutor rod to master cylinder . Pulled Completely off at the larger end of master cylinder.2014 Puma FTD 250 XS

    #454804

    Markw8859
    Participant

    FYI : per the factory that makes the brake actuator , after backing your boat in place you should always block your wheels & pull forward to release your brakes. Or rust can build up on push rod & cause leaky seals.2014 Puma FTD 250 XS

    #441537

    Markw8859
    Participant

    I just release the rachet all the way, put out the strap completely out . then fold up cover. Then unlock the ratchet from motor bracket all by its self. then it store it by its self. this way no accidental dropping on gel coat.2014 Puma FTD 250 XS

    #337874

    Markw8859
    Participant

    I got my 2014 PUMA FTD with 250 Pro XS with a 25 fury. Is the factory now sending out 26 ??? Any one else have my set up?? I picked my boat up in October. 2014 Puma FTD 250 XS

    #290671

    Markw8859
    Participant

    Water temp was 52-552014 Puma FTD 250 XS

    #290674

    Markw8859
    Participant

    After following the post from Don , I found in both t-stats small rock chips and small pebbles. I put both t stats in a cup and poured hot water in till the t stat opened. then flushed out all pebbles . I then took a toothbrush and finished cleaning them. If u own a outboard u better learn this . Will save u big bucks!!2014 Puma FTD 250 XS

    #447642

    Markw8859
    Participant

    should I be getting rust on the hubs, leaking out of center plastic cones dripping on my rims?? I only c 1 out of 4 that is not rusting2014 Puma FTD 250 XS

Viewing 15 posts - 1 through 15 (of 35 total)

Skip to toolbar