Owner's Board

bamabassmaster

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 21 total)
  • Author
    Posts
  • #330466

    bamabassmaster
    Participant

    So what did you do with the manual one you took off?

    #460614

    bamabassmaster
    Participant

    Jimmy L wrote:93 200HP Mariner magnum EFI Had tune up done they found lot of trash in in fuel filters replaced some clean others took it out to try it out shot out of the hole run 76.6 took out next day smoked a lot barely got out of hole would not turn over 5300 rpm I think maybe fuel hoses need to be replaced there 24 years old maybe it stopping up filters and starving for fuel again what are your thoughtsJimmy, are you able to run 76.6mph? If so, how much jackplate & what prop are you running?

    #453130

    bamabassmaster
    Participant

    Time for new a new pair of readers

    #356302

    bamabassmaster
    Participant

    Whats your prop to pad?I noticed a change of ~500 rpm by dropping my motor to 3″ (from 2″) when I put a 25 Fury on.

    #333608

    bamabassmaster
    Participant

    By my count only 15-16 (not sure on Horton) are running MotorGuides. With 109 guys on tour, its not a good look for Motorguide to put it kindly.

    #442904

    bamabassmaster
    Participant

    Yeah, that new Vortex hood is the real deal!

    #266669

    bamabassmaster
    Participant

    Maybe a long shot, but is this boat still available?

    #266314

    bamabassmaster
    Participant

    Just posted here: viewtopic.php?f=66&t=38033

    #265094

    bamabassmaster
    Participant

    If my wifes new kitchen table doesnt come it today Ill get them tonight, else itll tomorrow. Likely ~90 on each based on whats written on the powerhead – but Im not sure at what point that was done.

    #265095

    bamabassmaster
    Participant

    Starboard top to bottom: 96, 95, 93Port top to bottom: 95, 90, 90

    #265003

    bamabassmaster
    Participant

    Ive got this one listed here: alabama-94-p2-t38033.html

    #265096

    bamabassmaster
    Participant

    .

    #464203

    bamabassmaster
    Participant

    The 25 fury should’ve given you a little more RPM. You may also need to raise your jack plate – just keep an eye on water pressure.

    I’ve got the same boat with a 99 Johnson 200 & a fury 25. I’m pretty sure my P2P is closer to 2.5″.

    #466528

    bamabassmaster
    Participant

    I’ll take it.  Can you send me a paypal invoice to [email protected] ?

    #464481

    bamabassmaster
    Participant

    Didn’t that motor have an “auto trim” feature? Not sure why a bump in the road would cause that to activate – probably a poor wire connection somewhere, maybe a short that’s created when the motor bounces?

Viewing 15 posts - 1 through 15 (of 21 total)

Skip to toolbar